MTD T/120 Gebrauchsanleitung Seite 13

SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international symbols and pictographs that may appear on this product.
Read the operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning, or caution.
May be used in conjunction with
other symbols or pictographs.
• WARNING - READ OPERATOR'S
MANUAL
Read the Operator's Manual(s) and
follow all warnings and safety
instructions. Failure to do so can
result in serious injury to the
operator and/or bystanders.
• WEAR EYE AND HEARING
PROTECTION
WARNING:
noise can cause severe eye injury and
hearing loss. Wear eye protection meeting
ANSI Z87.1-1989 standards and ear
protection when operating this unit. Use a
full face shield when needed.
• THROTTLE CONTROL
Indicates "HIGH" or "FASTEST"
speed.
• THROTTLE CONTROL
Indicates "IDLE," "LOW" or
"SLOWEST" speed.
• WEAR HEAD PROTECTION
WARNING : Falling objects can cause
severe head injury. Wear head
protection when operatin this unit.
• UNLEADED PETROL
Always use clean, fresh unleaded petrol.
• OIL
Refer to operator's manual for the
proper type of oil.
Thrown objects and loud
SYMBOL MEANING
• IGNITION SWITCH
ON / START / RUN
• IGNITION SWITCH
OFF or STOP
• HOT SURFACE WARNING
Do not touch a hot muffler or
cylinder. You may get burned.
These parts get extremely hot from
operation. When turned off they
remain hot for a short time.
• SHARP BLADE
WARNING : Stop the engine and
allow the tines to stop before
installing or removing tines, or
before cleaning or performing any
maintenance. Keep hands and feet
away from rotating tines.
• KEEP BYSTANDERS AWAY
WARNING: Objects can be
thrown from unit. Do not operate
unit without proper attachments
and guards in place.
• THROWN OBJECTS CAN
CAUSE SEVERE INJURY
WARNING: Keep all bystanders,
especially children and pets, at
least 15 meters (50 ft.) from the
operating area.
• CHOKE CONTROL
1 • FULL choke position.
2 • PARTIAL choke position.
3 • RUN position.
• PRIMER BULB
Push primer bulb, fully and slowly, 10
times.
13