Herunterladen Inhalt Inhalt Diese Seite drucken

BEROTEC MOFESSOR Benutzerhandbuch Seite 17

Vorschau ausblenden Andere Handbücher für MOFESSOR:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
O i l t a n k a n d m e t e r i n g v a l v e
The hose connection of the oil tank should be at the lowest point and the gold-coloured
vent at the highest point, so that no oil can escape. The dosing valve can be mounted
higher than the oil tank.
The oil tank is filled via a T-branch connector. For this purpose, the hose must be cut
and the branch piece inserted into the hose between the oil tank and the dosing valve.
The sealing cap at the end of the filling hose must remain fitted during operation. The
flow direction of the dosing valve is marked with an arrow. To disconnect the quick cou-
plings, the black locking edge must be pressed before the oil hose can be pulled off.
E l e c t r i c s
The chain oiler is delivered fully wired and tested. Only connect or disconnect the plugs
when the power is off.
Steps for electrical installation:
1.
Select installation location for the control unit
2.
Connect the dosing valve to the control unit
3.
Fit the rain switch and connect the plug connection to the control unit
→ Do not lay the cable in direct proximity to the ignition system
4.
Connect control cable (black/white) to switched 12V. Many manufacturers already
provide connections, often called „ACC2" or auxiliary consumer connection. Alter-
natively, the branching flat plug can be plugged into the connection of the horn
in many vehicles (not in BMW), or the power supply for parking light, tail light or
licence plate light can be used. The diverted current is extremely low (20mA). This
does not affect the electronics.
5.
Connect battery connection cable
Connect the ring eyelets to the plus (red) and minus (black) of the battery.
Notes: Continuous positive and control line can also be connected together to a swit-
ched power source (e.g. on-board socket, ACC2), provided that a sufficient power supply
(520mA) is guaranteed. The pluggable fuse holder must only be used when directly
mounted on the battery. It is not necessary when connecting to an already fused line
(max.10A).
English
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis