Quick Start Guide - Subaru SEDEFG6000 Benutzerhandbuch

Downloaded from www.Manualslib.com
Device Identification: SUBARU_xxxxx
Passcode: 1234
Connecting Turn on vehicle ignition
Pairing Press control button for
12 seconds
Answering a call
Press control button
quickly once
Ending a call Press and hold control
button for 2 seconds
Rejecting a call Press and hold control
button for 2 seconds
Adjusting the volume Press control button
repeatedly
Private call Press and hold control
button for 8 seconds
Redialling a number Press and hold control
button for 2 seconds
Voice dialling Press control button
quickly once
Erasing paired devices Press and hold control
button for 15 seconds
manuals search engine

Quick Start Guide

When the vehicle ignition is turned on, the
paired cellphone automatically connects to the
handsfree system. Connection is confirmed by
( * )
ascending beeps (dependent upon type of
phone).
If there are no paired phones, the system
automatically enters the pairing mode
(dependent upon type of phone).
Press and hold the button until you hear 3
beeps - after approximately 12 seconds.
Release and you will hear a long buzz. Find
the device on your phones Bluetooth menu and
enter the 1,2,3,4 code.
When the phone rings, press the control button
once to answer the call.
Press the control button for 2 seconds.
After a pause, the system will give an audible
beep to confirm disconnection.
Press the control button for 2 seconds until you
hear a audible beep to reject an incoming call.
During a call, the volume can be adjusted up
and down by short presses of the control button.
The volume level will cycle between min/max
with an audible double-tone at the top and
bottom of the scales.
During a call, you can transfer the
conversation to the handset by pressing and
holding the control button until you hear 2
beeps - after approximately 8 seconds.
In standby mode, press and hold the control
button until you hear single beep - after
approximately 2 seconds. The system will
automatically redial the last number.
In standby mode, quickly press the control
button to enter the voice dialling mode. Clearly
speak the name of the person you wish to call.
Press and hold the control button until you
hear four beeps - after approximately 15
seconds. The Bluetooth system memory is
erased.
Refer to your phones user guide to erase the
phone memory.
- 3 -