T+A D 10 Betriebsanleitung Seite 57

Problem:
Cause 1:
Remedy:
Cause 2:
Remedy:
Cause 3:
Remedy:
Cause 4:
Remedy:
Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Downloaded from www.Manualslib.com
The disc will not play once the disc
drawer is closed.
Disc not inserted correctly.
Position the disc centrally: printed face up.
Disc soiled.
Carefully clean the disc by wiping with a
soft cloth from the centre to the edge.
Replace the disc and try again.
Disc damaged in the area of the Table of
Contents (TOC). Disc unusable.
No remedy possible.
Machine has got very cold (e. g. after
transport), allowing condensation to form
on the laser sensor optics.
Leave the machine to warm up for about
an hour in a warm, well ventilated place.
Disc stops playing, or 'skips'.
Disc dirty or damaged.
Clean disc. Damage cannot be repaired!
When used in a non- system the
machine does not respond to remote
control commands, or
switched on by remote control.
E 2000 remote control receiver not con-
nected.
Connect the E 2000 remote
receiver as shown in wiring diagram.
Press the source select button 
  on the remote control handset to  
switch the machine on.
manuals search engine
Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
cannot be
control
 /  
57
' overheat overheat overheat overheat ' displayed, playback stopped
Device is over heated, too little flow of
cooling air
change the installation of your system to
provide sufficient cooling.
do not place the D10 on top of hot equip-
ment like amplifiers or surround receivers
Not possible to switch to multi channel
mode
Disc does not contain a multi channel
layer
no remedy, disc can only be played back
in Stereo.