To Adjust Initial Settings - Panasonic WHADC0916G9E8 Bedienungsanleitung

To adjust initial settings

Dealer
Select menus and determine settings according to the system available in the
household. It is recommended that all alterations of settings are done by an
authorised dealer or specialist.
• After initial installation, you may manually adjust the settings.
The initial setting remains active until the user changes it.
• Ensure the operation LED is OFF before setting.
• The system may not work properly if set wrongly. Please consult
an authorised dealer.
1 Press and
5 seconds until the display shows SETTING STATUS.
2 Press
or to select the menu.
3 Press
to enter the menu.
4 Press or to select Yes/No, or other options.
YES: to enable the menu
No: to disable the menu
5 Press to confirm.
Before Indoor Unit operate, its Capacity
Rank has to match with connected
Outdoor Unit. See below table for detail.
Model
Indoor Unit
WH-ADC0916G9E8
Menu (1 ~ 15)
1 Room Thermostat Connection
To select whether or not to connect to the optional room thermostat.
2 Indoor Backup Heater Selection
To reduce the heater power if unnecessary.
*Options of kW vary depending on the model.
3 Water System Freeze Prevention
To activate or deactivate the water freeze prevention when the
system is OFF.
4 * * Cooling/Heating Operation Interval
1, 2
To set the interval for COOL or HEAT mode during COOL + TANK or
HEAT + TANK mode.
5 * Tank Heat-up Interval
1
To set the interval for the water tank during COOL + TANK or HEAT
+ TANK mode.
6
F569865-SS1114-0.indb 6 F569865-SS1114-0.indb 6
simultaneously and hold for
Capacity Rank
Outdoor Unit
WH-UX09FE8 9
WH-UX12FE8 12
WH-UX16FE8 16
WH-UD09FE8 9
WH-UD12FE8 12
WH-UD16FE8 16
Process Black Process Black
Operation LED
Control Panel
System Capacity Rank Setting
The Capacity Rank can be set by Control Panel
1 Press and buttons simultaneously for 5
seconds.
2 Press or button to select menu CAP RAN.
3 Press button then press
to change capacity rank and press
confirm the outdoor capacity rank.
4 Press button and Exit to home display.
Default Setting
Setting
NO YES
*3 kW / 6 kW /
9 kW
9 kW
YES YES
0.5 hours ~
30 minutes
10 hours
1 hour 5 minutes ~
35 minutes 1 hour 35 minutes
Display
or button
button to
Display
NO
NO
08/01/2015 12:44:37 PM 08/01/2015 12:44:37 PM