System Overview; Operating Conditions - Panasonic WHADC0916G9E8 Bedienungsanleitung

Thank you for purchasing Panasonic product.
Before operating the system, read these operating
instructions thoroughly and keep them for future reference.
Table of contents
Safety precautions ................................................ 3-5
To adjust initial settings .......................................... 6-7
How to use ...................................................... 8-11
Cleaning instructions ............................................. 12
Troubleshooting ................................................ 13-14
Information ......................................................... 15
The illustrations in this manual are for explanation purposes
only and may differ from the actual unit.
They are subject to change without notice for future
improvement.

System overview

Open and Close Top Front Plate
Do not open or close the Top Front Plate by excessive
force.
To Open:
Top Front Plate
open
Bottom Front Plate
"click"
Control panel
"click"
Hold in position

Operating conditions

Water outlet temperature (°C)
(Min. / Max.)
Outdoor ambient temperature (°C)
(Min. / Max.)
* Above 55 °C, only possible with backup heater operation.
2
F569865-SS1114-0.indb 2 F569865-SS1114-0.indb 2
To Close:
"click"
close
Note:
Not recommended to open
the Bottom Front Plate.
(For authorised dealer/
specialist use only)
HEATING HEATING
(TANK) (CIRCUIT)
- / 65* 25 / 55
-20 / 35
Process Black Process Black
Before use, make sure the system
has been installed correctly by an
authorised dealer according to the
given instructions.
• Panasonic Air-to-Water is a split system, consisting
of two units: indoor and outdoor units. The indoor unit
consist of the hydromodule and 200L sanitary water
tank.
• These operating instructions describe how to operate
the system using the indoor and outdoor units.
• As for the operation of other products such as radiator,
external thermo controller, and underfloor units, refer to
the operating instructions of each product.
• System could be locked to operate in HEAT mode and
disable COOL mode.
• Some functions described in this manual may not be
applicable to your system.
• Consult your nearest authorised dealer for further
information.
* 1 The system is locked to operate without COOL mode.
It can be unlocked only by authorised installers or our
authorised service partners.
* Only displayed when COOL mode is unlocked
2
(Means when COOL mode is available).
Outdoor Unit
Power Supply Radiator
Indoor Unit
When the outdoor temperature is out
COOLING
of the range in the table, the heating
(CIRCUIT)
capacity will drop significantly and the
outdoor unit may stop operating for its
5 / 20
protection.
The unit will restart automatically after
16 / 43 the outdoor temperature returns to the
specified range.
Floor Heating
Fan Coil Unit
Shower
08/01/2015 12:44:35 PM 08/01/2015 12:44:35 PM