THOMSON ROC4218 Bedienungsanleitung Seite 7

TV DVD
0166
G
Check of the programming:
Method C – Programming by means
of code retrieval
Should none of the codes work, you still have the
possibility of retrieving the appropriate code without
having to perform any input.
SETUP
TV DVD
OK
OK
Check of the programming:
Method D – Automatic
code search
With this method, the remote control scrolls through
the full code list by sending an IR signal to the set to be
controlled remotely. Proceed as follows:
SETUP
SETUP
P+
P+
SAT
AUX
G
SAT
AUX
G
G
TV
G B DVD
OK
DVD
Method E – Programming for control of
a COMBO (combined TV-VCR, TV/DVD,
VCR/DVD, ... set)
Depending on the COMBO group (TV/VCR, VCR/
DVD, etc.) and the make, you will be required to
enter a single code for both devices in the COMBO, or
to enter two codes, one code per device. Consult the
separate list to discover this.
Before you start programming, you must fi nd the
subcode or code of the subset to be controlled
(television or video recorder, ...). Refer to the list
supplied with this user manual (see page subcodes
or codes).
SETUP
How to retrieve
a programmed code
It may be useful to retrieve the code programmed in
the remote control.
SETUP
TV
SETUP
9
Check of
the programming
When you have retrieved the code of
your set, jot it down so that you can use it
whenever needed.
After battery replacement, you may have to
programme the remote control again.
TV CODE
DVD CODE
2
P-
G P+ B DVD
DVD SAT
AUX
2
B
Method B
AUX CODE
STB CODE
E
0
B
C