Faq - Südwind Ambientika SOLO Handbuch Für Installation Und Wartung

FAQ

The product doesn't start
The product properly
starts but doesn't get any
signal from the remote
control
The product properly
starts, gets signals from
the remote control but
the impeller doesn't turn
The product doesn't get
any signal from the
remote control and the
red led flashes
The product runs only in
extraction and the red led
is ON
No communication
between MASTER and
SLAVE units
WARNING: If the problem detected is different from those listed above or whether the
problem is not solved after following the indications, need to contact an authorized service
center.
Ensure that the product is properly connected to the mains.
Ensure that the ON/OFF switch (I/O) is in ON (I) position.
Ensure that the remote control is including the battery.
Ensure that the battery in the remote control is charged.
The commands re received only by the MASTER unit of the
system, make sure to send the commands to the right unit.
Ensure that the dip switches are properly set (MASTER).
Need to wait 40 seconds for the automatic shutter starts
opening
Ensure that the product is not in surveillance mode
Ensure that the impeller is not obstructed
Perform maintenance and filter reset as indicated in the
manual.
Ensure that the remote control is including the battery.
Ensure that the battery in the remote control is charged.
Raise the threshold of the hygrostat with H button.
Ensure the proper connection among the units
Ensure that the dip switches are properly set