Lighting The Ecosmart™ Burner; Regulating The Flame; Turning Your Ecosmart™ Fire Off - Extinguishing The Flame - EcoSmart Fire One Bedienungsanleitung

ENGLISH How to operate the EcoSmart™ Fire
Lighting the EcoSmart™ Burner
Keep hands and face well away from the EcoSmart™ Fire at all times, particularly when igniting.
2
1
Before lighting, ensure that the EcoSmart™ Burner is clear and ready for use. When lighting the
EcoSmart™ Burner the slider must be positioned at max to allow for correct ventilation.
Do not smoke while lighting the Burner, and make sure that no smokers are in front of the fireplace while
igniting the Burner. Only use the lighter supplied with your EcoSmart™ Fire.
1. Dip the lighting rod tip into the chamber opening "Burner zone" to wet the end.
2. Lift the lighting rod away from the Burner (do not drip fuel on the floor).
3
3. Ignite the lighter and make contact with the lighting rod as if lighting a candle.
4. Dip the ignited lighting rod back into the Burner zone to ignite the contained fuel.
NOTE: The XL Burner is best ignited from the right hand side of the ignition zone.
Once lit there will be a residual flame on the lighting rod that must burn out before putting the rod away. If the
flame on the lighting rod dies before reaching the burner, repeat the procedure until successful.
Due to the natural oils in the fibres we use in the EcoSmart™ Burner there is a stronger than usual smell when
first operating. It will decrease substantially after the first few times you use the Burner, and even more so over
4
time.

Regulating the flame

Wait until the fire is established (approx 10 minutes) before regulating.
To decrease the flame intensity insert the lighting rod tip through the circular ring and push forward gently to
desired setting. Only use the lighting rod supplied with your EcoSmart™ Fire to avoid hand burns.
To increase the flame intensity insert the lighting rod tip through the circular ring and pull back gently to
desired setting. Only use the lighting rod supplied with your EcoSmart™ Fire to avoid hand burns.
XL Burner: Feature not available in XL Burner.
Turning your EcoSmart™ Fire Off - Extinguishing the flame
Insert the lighting rod tip through the circular ring and push forward firmly until completely closed and in the
OFF position. Only use the lighting rod supplied with your EcoSmart™ Fire to avoid hand burns. If you do not
burn the Denatured Ethanol* until empty then you must not add more Denatured Ethanol * to the Burner OR re-
ignite the Burner for 30 minutes so it has cooled to room temperature. When there is no more fuel, the fire will
go out with nothing to clear or clean ready to be re-started when cooled.
XL Burner: The XL Burner has a Flip Lid shut off system. The lid flips across the ignition zone which
extinguishes the flame.
Around Burner: The Around Burner Lid is used to extinguish the flame.
17 © Copyright 2004 - 2011 The Fire Company Pty Ltd. All rights reserved. V7 0910.
Downloaded from www.Manualslib.com manuals search engine