Paj GPS POWER FINDER 4G Bedienungsanleitung Seite 21

1) Open the housing cover
2) Remove the rubber cover
3) Slide the slider to "ON"
4) Put the rubber cover
back into the device
5) Click the housing cover back
into the device
Note: In order to carry out an action, please ALWAYS wait
The FINDER is then switched on and off using the button located
under the cover on the side. To do this, this button must be
pressed for approx. 5 seconds.
After switching on the FINDER, the red LED and the battery
indicator go out automatically after 3 minutes.
When the FINDER is switched off, the red LED and the battery
indicator continue to light up for approx. 10 seconds in order to
transmit a last position.
To check whether the FINDER is switched on, please briefly
press the ON / OFF button once.
BEHAVIOR
The red LED and battery
indicator light up for
approx. 20 seconds
The battery indicator lights up
for a few seconds
until all LEDs are off!
How do I see if the FINDER is on?
POWER Finder 4G by PAJ with Online-Tracking V.1.0 EN
© PAJ UG (haftungsbeschränkt)
S
TATUS
FINDER is switched on
FINDER is switched off
21