ASROCK B75M-ITX Handbuch Seite 25

USB 3.0 Header
(19-pin USB3_3_4)
(see p.2, No. 12)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 10)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2, No. 15)
Downloaded from www.Manualslib.com
IntA_P0_D+
IntA_P0_D-
GND
IntA_P0_SSTX+
IntA_P0_SSTX-
1
IntA_P1_SSTX+
GND
IntA_P1_D-
IntA_P1_D+
DUMMY
1
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't need
to connect them for AC'97 audio panel.
E. To activate the front mic.
®
For Windows XP / XP 64-bit OS:
Select "Mixer". Select "Recorder". Then click "FrontMic".
®
For Windows 7 / 7 64-bit / Vista
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
ASRock B75M-ITX Motherboard
manuals search engine
Besides two default USB 3.0
ports on the I/O panel, there is
one USB 3.0 header on this
GND
IntA_P0_SSRX+
motherboard. This USB 3.0
IntA_P0_SSRX-
Vbus
header can support two USB 3.0
ports.
Vbus
IntA_P1_SSRX-
IntA_P1_SSRX+
GND
IntA_P1_SSTX-
This header can be used to
connect the remote
controller receiver.
This is an interface for front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
TM TM
/ Vista 64-bit OS:
25