Environment Protection; Control Panel; Switching Off - Zanussi ZFT710W Benutzerinformation

• This product must be serviced by an authorized Service
Centre, and only genuine spare parts must be used.

Environment Protection

This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be

Control panel

1 Green Indicator Light
2 Red Indicator Light
3 Yellow Indicator Light
4 Freezer Switch
5 Temperature Regulator
Switching on
1. Allow the appliance to stand for 4 hrs after installa-
tion.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clockwise to a medi-
um setting.
4. The Green Indicator Light will light up and remain lit
until the appliance is switched off at the mains.
5. Press the Freezer Switch to activate the fast-freeze
function (Yellow Indicator Light will illuminate) and
leave to run for 4 hours to allow the correct tempera-
ture to be reached before placing food inside.
Yellow Indicator Light lights in the switched-on state
of the Freezer Switch.
6. The Red Indicator Light will also illuminate until the
correct temperature is reached.
A few hours after starting up the Red Indicator Light
will go out to show that the correct temperature has
been reached for the setting chosen and will stay out
to indicate that everything is in order. It will come on
Downloaded from www.Manualslib.com
1 2
manuals search engine
discarded together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol are recyclable.
3 4
if the freezer temperature rises unduly for instance, af-
ter opening the freezer door or placing food inside the
cabinet, but the light should go out again when the
temperature returns to the correct storage level.
7. When the appliance has reached the set temperature
(the Red Indicator Light has gone out) press the
Freezer Switch again to switch off the fast freeze func-
tion. The Yellow Indicator Light will go out.

Switching off

1. To turn off the appliance, turn the Temperature Regu-
lator to the "O" position.
2. To disconnect the appliance from the power discon-
nect the mains plug from the wall socket.
Temperature regulation
The temperature within the appliance is controlled by the
Temperature Regulator situated on the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature Regulator toward higher settings
to obtain the maximum coldness.
A medium setting is generally the most suitable.
5
31