Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance; Sleep Timer Operation - Toshiba RAS-107SKV Serie Bedienungsanleitung

Air conditioner (split type)
Vorschau ausblenden Andere Handbücher für RAS-107SKV Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
11
TEMPORARY OPERATION
In case of the misplaced or discharged remote control
Pressing the RESET button, the unit can start or stop without
using the remote control.
Operation mode is set on
AUTOMATIC operation, preset
temperature is 25°C and fan
operation is automatic speed.
12
TIMER OPERATION
1
Press
2
Press
Press
3
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
Press
2
Press
During the daily timer is activating, both arrows ( , ) are indicated.
Note:
Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
The setting will be saved for the next same operation.
13
PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by
the unit for future operation (except airfl ow direction).
1. Select your preferred operation.
2. Press and hold
The P mark displays.
3. Press
14
AUTO RESTART OPERATION
To automatically restart the conditioner after the power failure (Power of the
unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds
to set the operation. (3 beep sound and OPERATION lamp blink 5
time/sec for 5 seconds)
• Do not operate ON timer and OFF timer.
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
blink)
15
QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
Press
Note: Under certain conditions, QUIET operation may not provide adequate
cooling or heating due to low sound features.
16
COMFORT SLEEP OPERATION
To save energy while sleeping, automatically control air fl ow and
automatically turn OFF.
Press
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation, the set temperature will decrease.
17

SLEEP TIMER OPERATION

To start the sleep timer (OFF timer) operation
Press
1110250170_EN.indd 3
1110250170_EN.indd 3
Downloaded from
www.Manualslib.com
Setting the ON Timer
Setting the OFF Timer
Press
ON
: Set the desired
OFF
ON timer.
: Set the timer.
Press
SET
SET
: Cancel the
Press
CLR
CLR
timer.
3
: Set the ON
ON
Press
timer.
Press
4
: Set the OFF
OFF
during the ( or ) mark
timer.
fl ashing.
PRESET
for 3 seconds to memorize the setting.
PRESET
: Operate the preset operation.
QUIET
: Start and stop the operation.
COMFORT
SLEEP
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
SLEEP
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
manuals search engine
18

MAINTENANCE

Firstly, turn off the circuit breaker.
Filter Reset (Some models only)
FILTER lamp lights on; the fi lter must be cleaned.
To turn off the lamp, push the RESET button on the indoor unit or the FILTER
button on the remote control.
Indoor Unit and Remote Control
Clean the indoor unit and the remote control with a wet cloth when
needed.
No benzine, thinner, polishing powder or chemically-treated duster.
SELF CLEANING OPERATION
19
(COOL AND DRY OPERATION ONLY)
: Set the desired
OFF timer.
To protect bad smell caused by the humidity in the indoor unit.
1. If the
: Set the timer.
fan will continue to run for other 30 minutes, then it will turn off
: Cancel the
automatically. This will reduce the moisture in the indoor unit.
timer.
2. To stop the unit immediately, press the
seconds.
20
OPERATION AND PERFORMANCE
SET
.
1. Three-minute protection feature: To prevent the unit from being
activated for 3 minutes when suddenly restarted or switched to ON.
SET
button
2. Preheating operation: Warm up the unit for 5 minutes before the
heating operation starts.
3. Warm air control: When the room temperature reaches the set
temperature, the fan speed is automatically reduced and the outdoor
unit will stop.
4. Automatic defrosting: Fans will stop during defrost operation.
5. Heating capacity: Heat is absorbed from outdoors and released into
the room. When the outdoor temperature is too low, use another
recommended heating apparatus in combination with the air
conditioner.
6. Consideration for accumulated snow: Select the position for outdoor
unit where it will not be subjected to snow drifts, accumulation of
leaves or other seasonal debris.
7. Some minor cracking sound may occur when unit operating. This is
normal because the cracking sound may be caused by expansion/
contraction of plastic.
Note: Item 2 to 6 for Heating model
Air conditioner operating conditions
Operation
Heating
Cooling
Dry
21
TROUBLESHOOTING (CHECK POINT)
The unit does not operate.
• The power main switch is
turned off.
• The circuit breaker is
activated to cut off the power
supply.
• Stoppage of electric current
• ON timer is set.
22
REMOTE CONTROL A-B SELECTION
To separate using of remote control for each indoor unit in case of 2 air
conditioner are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold CHK
pencil. "00" will be shown on the display.
4. Press
"00" will disappear and the air conditioner will turn OFF. The Remote
Control B is memorized.
Note: 1. Repeat above step to reset Remote
Control to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
button is pressed once during "Cool" or "Dry" mode, the
more 2 times within 30
Temp.
Outdoor Temperature
Room Temperature
–15°C ~ 24°C
Less than 28°C
–10°C ~ 46°C
21°C ~ 32°C
–10°C ~ 46°C
17°C ~ 32°C
Cooling or Heating is abnormally low.
• The fi lters are blocked with dust.
• The temperature has been set
improperly.
• The windows or doors are opened.
• The air inlet or outlet of the outdoor
unit is blocked.
• The fan speed is too low.
• The operation mode is FAN or DRY.
button on the Remote Control by the tip of the
MODE
during pushing CHK
. "B" will show on the display and
EN
ES
FR
IT
DE
PT
PL
CZ
CR
HU
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI
12/23/09 3:46:31 PM
12/23/09 3:46:31 PM

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis