Programming; Understanding The On-Screen Display; On-Screen Display - Honeywell HCC484TP Benutzerhandbuch

Programming

Understanding the On-Screen Display

Press MENU briefly to confirm the current operation setup. The
information (see
is no button action.
Even though the OSD message disappears the Camera ID or Title
will continue to display. If you do not wish to display the ID, you can:
• With external communication, change the display position.
Options are: Bottom right, Bottom left, Top left, Top right, Non
display.
Figure 8
CAM ID/TITLE
Note If you do not need to display the Operating OSD (for
example, for an external text overlay board), it can
be set to OFF at all times through a remote control
using RS485 connection.

On-Screen Display

Use the OSD (On-Screen Display) to program the camera.
1. Press and hold the MENU (center) button for 2 seconds to
display the Setup menu.
2. Press the UP or DOWN buttons to select a menu item.
3. Press the MENU button to enter the selected submenu.
Rev 1.01
Figure 8) will disappear after a few seconds if there
OSD Information Display
Back
Light
CAM ID/TITLE
CAM ID/TITLE
Shutter WB
Speed Mode
CAM ID/TITLE
8 900.0512
07/06