Adding A Camera Title Display - Honeywell HCC484TP Benutzerhandbuch

Menu Item Option
8
SYNC
CONTROL
9
RESTORE
DEFAULT

Adding a Camera Title Display

To add a camera title:
1. Enter the SETUP MENU, select CAMERA ID and press MENU.
2. Use the UP, DOWN, +, – buttons to select a character in the
TITLE to start editing with.
3. When the position is set, use the UP, DOWN, +, – buttons to
move between the alphanumeric characters. When the desired
character is blinking, press MENU to accept it. The character
appears in the title at the bottom of the screen. The cursor will
automatically highlight the next position in the TITLE.
4. Repeat step 2 until your camera title is complete.
5. Use the + and – buttons to change the DISPLAY field to
TITLE.
6. Select RETURN and press MENU to accept your changes and
return to the main SETUP MENU.
Note For remote control using RS485 connection, you can
select either Camera ID or Title to display.
Figure 11
Rev 1.01
AUTO
INT
L/L
RESTORE DEFAULT
SETTINGS
Adding Camera Title
CAM ID: 002
DISPLAY: TITLE
POSITION: T.R.
1 2 3 4 5 6 7 8 9 A B C D E F
G H I J K L M N P Q R S T U V W
X Y Z a b c d e f g h i j k l m
n o p q r s t u v w x y z , . :
; ~ ! ? $ % * & / < > + - =
TITLE: HCC484TP
RETURN
12
Description
See Sync Control Setup
more information.
Restore the factory default
settings. If you have not
made any changes, you will
not be able to select this
setting.
for
900.0512
07/06