Mounting The Camera; Connecting The Camera - Honeywell HCC484TP Benutzerhandbuch

Mounting the Camera

Mounting points are provided on the top of the camera for mounting
the camera on a bracket or tripod. They are designed to accept
standard sized mounting bolts. This bracket can be unscrewed and
mounted onto the opposite side of the camera, depending on your
application. The mounting bracket must be capable of supporting
the weight of the camera and its lens.
Note Some installation codes dictate that the mounting
bracket must be capable of supporting up to four
times the combined weight of the camera and lens.
Figure 5
Unscrew 3 bracket
securing screws and
then resecure the
bracket on the other
side of the camera.

Connecting the Camera

Note Check the power source from the external power
supply before applying power to the camera.
1. Connect the VIDEO connector on the rear of the camera to the
video-in connector on your monitor.
2. Connect the camera to a 12 VDC or 24 VAC power supply
(appropriate for your installation).
3. Plug in the power supply. The power LED illuminates to show
that the camera is receiving power. If it does not illuminate,
check the connections and the power source.
WARNING!
Rev 1.01
Camera Mount
The use of a CSA Certified/UL Listed
Class 2 power supply is required to
ensure compliance with electrical
safety standards.
6 900.0512
07/06