Viewing The Logging Information; Programming Holiday Periods - Thomas & Betts ENERGYMIZOR 2 Gebrauchsanleitung

1) User Code -
2) Overwork Code - This code gives access to the Overwork and
To change the code, simply enter the new code when prompted.
Press RUN to return to the Normal RUN mode.
Logging
PROG / USER CODE / 3) SYSTEM / 3) LOGGING
The Energymizor 2 records hours run and temperature and burner history. Hours run is a weekly total and is
stored for the previous 12 months. The temperature and burner history is recorded every 15 minutes and is
also stored for 12 months.
Pressing 1 shows you this weeks hours run total. Pressing the left arrow
allows you to scroll through the previous weeks. Using the right arrow
allows you to scroll back up to the present date.
Pressing 2 shows you the last recorded temperature and burner status.
Pressing the left arrow allows you to scroll through the records (15 minute
intervals). Using the right arrow allows you to scroll back up to the last record.
4) Holidays
Press the program key, enter user code and select option 4.
This is the section used to set the known holiday periods for the year when heating in the zone will not be
required.
Five holiday periods can be set. Follow the steps below for instructions on how to set the holiday periods.
• You are now prompted to enter the holiday period 1.
You must enter the start date in the DD-MM-YY format. When you
have programmed the start date of the holiday press enter.
• You should now program the length of the holiday. You should calculate the number of days you want
the heating off by counting from the first day of your holiday until the last. Now enter the length.
• When the first holiday period is set press the enter key.
• Holiday period 2 will now be displayed.
You should program the remaining holiday periods in the same way. When all of the holiday periods have
been programmed the control will revert back to the Data menu.
Important Note:
1. If enter is pressed at any time then the current setting will be retained.
2. To cancel the holiday, put the date to 00.00.00 and length to 00. The holiday will then be cancelled.
This code gives access to all data settings
of the user.
Summer functions.
6
1) USER CODE
2) OVERWORK CODE
CODE NOW: 0000
NEW CODE:????
1) HOURS RUN
2) TEMP & BURNER
HOLIDAY PERIOD 1
S:00-00-00 L:00