System Specifications; Specification - Thomas & Betts ENERGYMIZOR 2 Gebrauchsanleitung

• You are now prompted to select whether you require
"Local" "Lock" or "Full" access.
"Local" = This means that the Energymizor can be used locally, but cannot be used to access other
Energymizors on the network.
"Lock" = This means that the Energymizor will be locked and cannot be used
"Full" = This means that the Energymizor can be used locally, and can also be used to access other
Energymizors on the network.
• You are now prompted to select whether you want to give
"Remote Reset" facility. If enabled, the user will be notified when
any heater goes to lockout. This information will be displayed on
the Energymizors that have been setup to offer "full" access. The
user will also be able to send a reset signal via the network to reset
the heater which is at lockout.
Setting up Station 1 (You should do this last)
• You will be prompted to enter a Network code when setting up
Outstation 1. This is a 4 digit code that you will be able to use to
gain access to all the other Energymizors on the network. When you
enter this code, it will be sent to all Energymizors on the system.
• You will be prompted to enter the number of controls on
the system.
Enclosure: ABS Fire Retardant
Dimensions: 222mm x 156mm x 61mm (Length, Height, Depth)
1.3 kg
Weight:
Relays: Relay 1-3 normally open contacts
Relay 4 normally open, normally closed contacts
10 amp 230v rating relays 1-3
Alarm Input: 230v AC. 5mA Max.
Supply: 230v AC ± 10% 50Hz
Sensors: Only use Energymizor Sensors. Twin screened cable (Beldon 8451)
Battery: 3 years (Replacement battery: CR2430)
Fuses: FS1: 800mA Antisurge
FS2: 315mA Quick blow
FS3: 315mA Quick blow

SYSTEM SPECIFICATIONS

16
"ACCESS? LOCAL<0>"
"LOCK<1> FULL<2> "
" ALLOW REMOTE
RESET? N<0> Y<1> :0 "
"SET NETWORK CODE"
" XXXX
"ENTER NUM OF CTL"
"1 TO 30:
"
"