Network Control; Programming Across The Network - Thomas & Betts ENERGYMIZOR 2 Gebrauchsanleitung

System explanation:
• Up to 30 Energymizors can be connected together to allow for central control of the heating system.
• The communication link is only used when copying/viewing data from a networked Energymizor. This
means that should the communication link fail, the heating system will continue to work as normal.
• The design of the Energymizor network systems means that there is no "Master keypad" Each Energymizor
can be setup to allow full network access, only local access or no access at all (keypad locked)
• Only 1 Energymizor can be programmed over the network at any one time.
Operating Normal RUN Mode functions on a networked Energymizor
Normal RUN mode functions are:
1. Fan
2. Override
3. Summer mode
4. View set-point and time-clock status
5. View current time and date
6. Reset a lockout status
• Use the left/right arrow keys to scroll around the network. The title of each Energymizor will be displayed
as you scroll the network.
• Press Prog
• The display will inform the user that the control is entering REMOTE MODE
• The user can now perform any Normal Run mode operation as described on pages 2-4 of this
manual
NB: In Normal Run mode, the following applies.
After 4 minutes of inactivity, the remote connection will time-out.
You can disconnect from the networked Energymizor by pressing the PROG key. To close the network
connection, press RUN.
To begin programming a networked Energymizor, follow the steps below;
• Press Program and enter the "Network Access Code".
The network code can be found on the data label in the product.
• You are now presented with two options.
Use Local Data: You should use this option if you want to program the local Energymizor and want the
ability to copy the data to a networked Energymizor.
You are now prompted with this menu.
ENERGYMIZOR 2
Network User Section
Programming a networked Energymizor
13
"1) USE LOCAL DATA"
"2) USE NW DATA "
1)TEMP 2)DATA
3)SYSTEM 4)HOLS