Network Setup - Thomas & Betts ENERGYMIZOR 2 Gebrauchsanleitung

System Code
• Press Prog and enter the security code
• Pressing 3 for System
• Pressing 4 for Code prompts you to select the code you wish to alter
1) User Code - This code gives access to all data settings of the user
2) Overwork Code - This code gives access to Override, Fan, Summer functions.
4) HOLS (Holidays)
When you select HOLS, you are presented with an additional screen
over the standard programming mode. This screen gives you the
ability to copy holiday periods to other Energymizors on the network.
Select 1 to program the holiday periods.
Select 2 to begin copying the holidays
When you press 2 for Copy, you are prompted with this screen.
1> Zone. This allows you to select a zone by using the left/right arrow keys.
When you have selected the zone you wish to copy the Hols to, press Copy
2> All. Selecting this allows you to copy the times to all Energymizors on the network.
Use NW Data: This allows the user to select and program a networked Energymizor. Under this mode you
cannot program the Local Energymizor and the global copy function will not copy the data to the Local
Energymizor.
• Pressing the Back and Forward arrows keys will display the name
of the Energymizors available on the system.
• When you have identified the Energymizor you wish to program,
wait 5 seconds and the Energymizor will automatically display the
following display.
• Follow the instructions on 2-3 for programming details in this mode.
In order to setup the Energymizor on the network, follow the steps outlined below.
You should repeat these steps for each Energymizor on the network.
Important: Setup outstation 1 last.
• Press Program and enter the network setup code.
(The network setup code can be found on the data
label inside the product)
• You are now prompted to enter the station number.
You should enter a two digit number for each Energymizor on the
network. One Energymizor must be given the ID number 01
• You are now prompted to enter a title for this Energymizor. You are
able to set a title up-to 11 characters long. Enter the title by using
the alphabet keys to select the required letter, and enter to accept.
Network Setup Section
15
"HOLIDAYS"
1) SET 2) COPY
"COPY HOLS"
1>ZONE 2>ALL
"!SELECT CONTROL!"
" BACK FWD "
"1) TEMP 2) DATA"
"3) SYSTEM 4) HOLS"
" ** WARNING **"
"ENTRY CODE:????"
"NETWORK ID NUM"
"FOR THIS UNIT: XX"
"CONTROL NAME?"
"XXXXXXXXXXX "