Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Powerlink 4; Basic Setup And Use - AbleNet Powerlink 4 Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für Powerlink 4:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Using the PowerLink 4

Basic Setup and Use

1.
Plug the PowerLink into any AC wall outlet with the cord provided and turn the device ON.
2.
Plug appliance(s) to either power cable on the side of the PowerLink and turn the
appliance(s) ON.
Note: For pressure sensitive switches, consider tape or a Velcro® strap to hold the
button down.
3.
Test your AC power connection by pressing the appropriate Test button. The attached
appliance should activate.
4.
Attach any corded, single switch(es) to the corresponding switch jack(s)
5.
Press the Mode button until the "Direct" mode LED lights up.
6.
Press and Hold switch(es) to activate their corresponding appliances. Release to turn OFF.
PowerLink's Status lights will activate and remain on whenever the PowerLink receives
switch input.
Linking with AbleNet Wireless Switch Transmitters
The PowerLink can be controlled by any AbleNet wireless* switch transmitter such as the Jelly
Beamer®. Linked devices can access the PowerLink from up to 30 feet away without pointing or
"line of sight".
Up to 8 AbleNet wireless switch transmitters can be linked to one or both sides of the PowerLink,
and will only activate sides that they are linked to.
To link AbleNet wireless switch transmitters:
1.
Turn both the PowerLink and AbleNet wireless switch transmitter ON.
2.
Press and Hold PowerLink's Status button on the side you wish to link for
6-10 seconds until the light turns solid Green.
3.
Activate any AbleNet wireless switch transmitter.
PowerLink's corresponding light will blink Red, then Green.
Repeat this step to link as many as 7 additional AbleNet wireless switch
transmitters on that side.
4.
Press and Release Status button to exit linking mode.
PowerLink's corresponding light will turn off.
5.
Repeat steps 2-4 for opposite side.
NOTE: Once you exit linking mode, re-initiating the linking process will overwrite
all previously linked devices.
To un-link AbleNet wireless switch transmitters:
Press and Hold the desired Status for 10-15 seconds until the light blinks Red
3x, then Green, then off.
*For a complete list of AbleNet wireless switch transmitters, visit www.ablenetinc.com.
.
5

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für AbleNet Powerlink 4

Diese Anleitung auch für:

1001070110010702

Inhaltsverzeichnis