Environmental Protection; Troubleshooting - Kress KUV12P Bedienungsanleitung

INTENDED USE
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines, while
resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
Saw Blade Assembly and
Removing
Safety On/Off Switch
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Cross and Rip Cutting
Parallel Guide
Cutting Depth Adjusting
Cutting Angle Adjusting
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition
and the tooth count of the saw blade. Therefore, use
only sharp saw blades that are suited for the material
TROUBLE SHOOTING
Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than
that is set.
Blade spins or slips
Blade will not cut a straight
line.
Blade kicks back when
beginning a cut
Figure
See Fig. A
See Fig. B
See Fig. C1, C2
See Fig. D1, D2
See Fig.E1,E2
See Fig. F
See Fig. G1,G2
See Fig. H
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very fine
cuts into delicate surfaces, diamond for tile, cement
board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base
to ensure proper performance.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
Possible Solution
Check to make sure power cord is connected
well into a working outlet.
Unplug the power cord. Replace it using a
qualified maintenance person.
Replace the carbon brush using a qualified
maintenance person.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Remove the blade, and reassemble it as
described in INSTALL/CHANGE THE
BLADE section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full speed prior
to beginning a cut in the material.
13
EN