Installation Instructions - Sharp EBR-4800 Installationsanleitung

A32867,EBR-4800
1. (For U.K. use)
A cut-out w ill have to be provided in the side of the kitchen cabinet for the plug of the oven.
N.B.The m ains plug m ust be accessible after installation or an all-pole sw itch disconnection m ust be
provided w ith a contact separation of at least 3 m m in each pole.
(For Continental use)
The electric outlet m ust be installed at 150 m m high from the floor of the built-in cabinet and at 50 m m
from the right w all of the built-in cabinet as show n in Fig. 1. The m ains plug m ust be accessible after
installation or the oven m ust be connected to an electric circuit provided w ith an all-pole sw itch (contact
gap no less than 3 m m ) to disconnect the oven in case of danger. A safety-device like a fuse in the
installation m ay be used as a sw itch.
2. Rem ove the built-in kit from the package.
3. Set the spacing brackets
a distance of 7m m betw een the front end of the shelf and the spacing brackets, and attach them w ith
the four screw s
Caution:
4. (Carry out this step 4 only for B type m odels)
Rem ove the screw
tab of the air duct
5. (Carry out this step 5 only for B type m odels)
Rem ove the screw
tabs of the back plate
6. Rem ove the one screw
7. Insert the tab of the exhaust duct
to the rear of the oven w ith one screw
8. Let the power supply cord pass through the hole of the lower side of the intake duct
9. Install the intake duct
in Fig. 4.
Caution:
10. Rem ove the backing paper from the three cushions
intake duct
11. (For U.K. use)
Place the oven on the spacing brackets on the shelf of the kitchen cabinet feeding the pow er supply cord
through the prepared cut-out.
(For Continental use)
Place the oven on the spacing brackets on the shelf of the kitchen cabinet.
12. Connect the oven to the pow er supply.
Caution: a. In U.K., connect the oven to the pow er supply 230-240 V, 50 Hz.
13. Adjust the position of the oven so that the feet of the oven are fitted into the recesses of the spacing
brackets as show n in Fig. 2.
Caution:
14. Place the built-in fram e elem ent
horizontally. Secure loosely to the kitchen cabinet w ith tw o screw s
15. Insert tw o built-in fram e side elem ents
And secure tw o screw s
and left built-in fram e side elem ents
Note: Fit the hole of the built-in fram e side elem ent
16. Install the second built-in fram e elem ent
the oven. And secure the built-in fram e elem ent
8
Caution:
Downloaded from: http://www.usersmanualguide.com/

INSTALLATION INSTRUCTIONS

1
on the shelf along the right and left w alls of the kitchen cabinet, keeping
9
, as show n in Fig. 1.
The arrow m arks on each spacing bracket should be pointing tow ards you.
F
holding the air duct
G
from the slit of the rear of the oven. Then rem ove the air duct
H
holding the back plate
I
from the slits of the rear of the oven.
E
from the oven as show n in Fig. 3.
3
to the rear of the oven w ith tw o screw s
Avoid pinching the pow er supply cord betw een the oven and the intake duct
3
and attach the cushions
b. In the Continent, connect the oven to the pow er supply 230 V, 50 Hz.
M ake sure that the pow er supply cord does not touch the air vent openings behind the oven.
A
tightly as show n in Fig. 6. Check location by m easuring distance betw een right
to the kitchen cabinet w ith tw o screw s
M ake sure that 6.5 m m of the fram es (upper and low er) and cabinet overlap each other as
show n in Fig. 8, or the kitchen cabinet door m ay touch the built-in fram e elem ents.
G
to the rear of the oven as show n in Fig. 3. And release the
I
to the rear of the oven as show n in Fig. 3. And release the
2
into the slit of the rear of the oven. And install the exhaust duct
0
as show n in Fig. 4.
4 5 6
, and
5 6
and at the top of the oven as show n in Figs 5-a and 5-b.
7
on top of the oven m aking sure that it is level both vertically and
8
betw een the built-in fram e elem ent
8
. The distance is stated in Fig. 7.
8
to the screw
7
over the built-in fram e side elem ents
7
through the holes of the built-in fram e side elem ents
A
as show n in Fig. 6.
2
2
G
from the oven.
3
as shown in Fig. 4.
E
0
and (rem oved at step 6) as show n
3
4
. Attach the cushion at the top of the
A
as show n in Fig. 6.
7
and the kitchen cabinet.
A
w hen inserting.
8
at bottom edge of
2
.
2