Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. (For U.K. and Australia use)
A cut-out will have to be provided in the side of the kitchen cabinet for the plug of the oven.
N.B.The mains plug must be accessible after installation or an all-pole switch disconnection must be
provided with a contact separation of at least 3 mm in each pole.
(For Continental use)
The electric outlet must be installed at 70 mm high from the floor of the built-in cabinet and at 280 mm
from the right wall of the built-in cabinet as shown in Fig. 1. Or the electric outlet should be provided in
the shaded area as shown in Fig. 1. The mains plug must be accessible after installation or the oven must
be connected to an electric circuit provided with an all-pole switch (contact gap no less than 3 mm) to
disconnect the oven in case of danger. A safety-device such as a fuse in the installation may be used as
a switch.
Caution :
When the electric outlet is provided under the floor of the built-in cabinet, it should be where
the power supply cord and plug of the microwave oven never touch an appliance installed
below the microwave oven.
2. Remove the built-in kit from the package.
3. Set the spacing bracket 1 on the shelf, keeping a distance of 29 mm between both side walls of the
kitchen cabinet and the spacing bracket, and attach them with four screws 5, as shown in Fig. 1.
Caution:
The arrow marks on each spacing bracket should be pointing towards you.
4. Place the sash angle 2 along the upper edge of the kitchen cabinet, keeping a distance of 25 mm at either
side of the sash angle 2. Attach it with 3 screws 5 from below the cabinet as shown in Fig. 3.
5. Install the oven into the kitchen cabinet.
Caution:
Two persons are required to install the oven. Never hold the door handle when moving the
oven.
Place the oven on a table/stand positioned in front of the kitchen cabinet where the oven is to be installed.
6. Connect the oven to the power supply.
Caution: a. In the U.K. and Australia, connect the oven to the power supply 230-240 V, 50 Hz.
b. In the Continent, connect the oven to the power supply 230 V, 50 Hz.
7. Make sure the oven is on the spacing bracket on the shelf of the kitchen cabinet. Then adjust the position
of the oven so that the feet of the oven fit into the recesses of the spacing bracket as shown in Fig. 2.
Caution:
Make sure that the power supply cord does not touch the air vent openings behind the oven.
8. Remove the 2 screws 7 to separate the lower built-in frame 4 from the built-in frame 3 as shown in
Fig. 8. Keep the screws 7 to use them at step 10.
9. Hang the built-in frame 3 over the sash angle 2 as shown in Fig. 4-1 and Fig. 4-2.
Attach the built-in frame 3, to the wall of the kitchen cabinet, with 2 screws 6 as shown in Fig. 4-1.
10. Set the lower built-in frame 4 into the built-in frame 3 and fasten them with 2 screws 7 (removed at step 8)
from below as shown in Fig. 5.
Check the location by measuring the distance between each built-in frame element. The distance is stated
in Fig. 6.
Caution:
Check the positioning of the built-in frame ensuring there is a 4.5 mm overlap at the top and
a 6.5 mm overlap at the bottom, ensuring there is no obstruction to adjacent cabinet doors,
as shown in Fig. 7.
INSTALLATION INSTRUCTIONS
2
Werbung
