SUNTEC DryFix 20 Bedienungsanleitung Seite 16

- The time can be set by the hour (0-24 h).
On Time:
- Press the TIMER button while the unit is turned off to determine the switch.
- The time can be set by the hour (0-24 h).
Auto-dehumidification
- Press the MODE button and select the AUTO dehumidifying mode.
- The unit starts automatically with dehumidification degree of 50%. You can set
the desired dehumidification by operating the HUMIDITY button.
- If the ambient relative humidity is higher than the adjusted dehumidification +
5%, the unit will run with a higher fan speed.
- If the level ambient relative humidity is in the range of the adjusted
dehumidification ± 5%, thus the device will run with lower fan speed.
- If the level of ambient relative humidity is smaller than the adjusted of
dehumidification -5%, the dehumidifying function will turn off, the device will run
with a lower fan speed.
High dehumidification
- Press the MODE button and choose the HIGH DEHUMIDIFYING mode.
- Under this setting, the unit dehumidifies without regarding the ambient relative
humidity, the fan runs faster. This cause the circulation of larger air volume.
Low dehumidification
- Press the MODE button and choose the LOW DEHUMIDIFYING mode.
- Under this setting, the unit dehumidifies without regarding the ambient relative
humidity, the fan runs slower. This cause the circulation of smaller air volume.
Air purifying
- Press the MODE button and choose the FAN mode
- Press the HUMIDITY button to adjust the fan speed
Internal drying
- The unit has an internal dehumidifying function. This allows keeping the unit dry
and mould-free, if it is not used for a long time.
- To activate this function, press and hold the MODE button for at least 2 sec to
remove the water from the device.
- The drying process takes about 45-60 minutes.
- To cancel this process press and hold again the MODE button, the unit will run
with the previous settings. Press the power button to stop the drying process
and to put the device into standby mode.
CONDENSATION WATER DRAINAGE
Water tank:
- When the water tank is full, the corresponding symbol blinks on the display; you
can hear the alarm sound.
- Please turn off the power and unplug the power cord.
- Pull out the water tank carefully, remove the tank lid and tilt the water out.
- Then put the lid back on and slide the water tank carefully into the device.