Maintenance; Waste Separation - BabySafe ES09 Bedienungsanleitung

MAINTENANCE

dsfdsdfs
General
Remove the car seat from the car before carrying out any maintenance work.
The seat can be cleaned with soap and lukewarm water. Do not use any abrasive
detergents.
The belt buckle can be cleaned using warm water. Do not lubricate.
The cover must be washed by hand (maximum 30 C). Do not use a dryer (also see
washing instructions).
Important! Never remove the energy absorbing foam.
Tip: It is advisable to buy an extra cover when purchasing the our
baby car seat, so that you can continue using it even when the cover
is being washed or dried.
Removing the cover
To Remove Seat Pad:
1. Remove shoulder harness.
2. Slide seat pad from car seat by gently pulling it off the top of car seat back.
Refitting the cover
1. To refit the cover, carry out the above instructions in reverse order.
2. Make sure that the lower section of the cover flaps over the uppersection.
3. Fasten the adjustment strap under the shell again

WASTE SEPARATION

To ensure optimum and safe use of car safety seats, they should not be used for
longer than 5 years after the date of purchase. Ageing of the plastic, for instance
under the influence of sunlight (UV), may quite unnoticeably reduce the qualities
of the product.
Once the child has grown out of the seat, we therefore advise you to no longer use
the car seat and to dispose of it in the proper way.
As we care for the environment we request the user to separate the waste produced
at the start (packaging)and end (product parts) of the life of the baby car seat.
17