INSTALLING IN YOUR CAR
dsfdsdfs
Important! Do not mix up hip (H-1,1) and shoulder part (H-1,2)!
Place the baby car seat in a rearward-facing position on the seat, therefore with
the back forward facing. The carrying handle must be locked in an upright position
(H-2).
Thread the lap section of the seat belt across the front (foot end) between the shell
and two blue belt hooks (H-3).
Place the shoulder section of the seat belt around the baby car seat and slide it into
the blue belt hook on the back.(H-4) .
Please make sure the shoulder belt is located between adapter and seat base. (H-5).
The retaining hook holds the seat belt in place (H-6). After fixing the baby car seat
onto the seat of car,push down the red button on the two sides of handle ,adjust the
handle to touch seat back of car(H-7).
Insert the tongue section into the buckle (H-8,3).Make sure the seat belt is not twist-
ed. Tighten it as much as possible. Check again to make sure the seat belt is thread-
ed through all three blue belt hooks.
NOTE: Vehicle must be parked on horizontal surface during this Installation
11