Connectable Power Sources; Connectable Devices; Intended Installation Locations; Safety - AEG 10057 Bedienungsanleitung

20 www.aeg-automotive.com

Connectable power sources

The voltage converter is intended for connection to
power sources with 12V direct current.
It must have sufficient capacity for the consumers
connected to the converter.
To calculate the required capacity, divide the con-
sumer load by the voltage.
Example: Consumer load 180 W : 12 V = 15 A
Connecting to power sources with an output voltage
other than 12 V direct current is prohibited and
improper.

Connectable devices

Allowed Not allowed
Devices with a total rated Devices with a total rated
voltage voltage
• 1000 W (10057) • 1000 W (10057)
< 1000 W
• 1500 W (10058) • 1500 W (10058)
< 1500 W
(also see "Technical (also see "Technical
Data"). Data").
Note:
The voltage converter provides a modified sinusoi-
dal voltage. To prevent consequential loss, please
verify the device to be powered is suitable (also see
"Technology").

Intended installation locations

The voltage converter is intended for installation in:
•
Cars and lorries
•
Caravans
•
Boats
Do not place the power inverter:
•
near heat sources (radiators, direct sunlight),
flammable materials, battery compartment or
starter battery
•
in damp locations or locations exposed to drip-
ping or splashing water
•
in explosive environments

SAFETy

General Safety Guidelines
Read all safety notes and instructions.
Failure to observe the safety notes
and instructions may result in electric
shock, fire and/or serious injuries.
Please keep all safety notes and in-
structions for future reference.
Risk of bodily or fatal injury to chil-
dren! Risk of suffocation or strangu-
lation! Keep the machine out of the
reach of children. Children are unable
> 1000 W
to assess the risks associated with
> 1500 W
use of this product!
Damaged leads may cause fatal elec-
tric shock. Discontinue use if leads are
damaged.
The manufacture is not responsible
for damages caused by:
•
•
•
•
Warning!
Danger!
Improper connection and/or opera-
tion.
External forces, damage to the de-
vice and/or damage to parts of the
device due to mechanical impacts or
overload.
Any type of modifications to the
device.
using the device for purposes not
described in this operating manual.