Operation Mode Manual; Operating Mode Clfb (Closed Loop Feedback) With Sensor Iq Easy - Simco Performax IQ Easy Bedienungsanleitung

- Click on Operation mode
- Select the desired operation mode
(Auto tune is not available at this time)

6.4.1 Operation mode Manual

After Manual mode is selected, go to the parameter Balance using the next page
- Click Balance,
- Confirm the selection by clicking
The ionisation will now be continued with this setting.

6.4.2 Operating mode CLFB (Closed Loop FeedBack) with sensor IQ Easy

After CLFB mode is selected, go to the parameter Paired sensor using the next page
symbol.
The sensor bar has to be connected to the Performax IQ bar now.
- Click Paired sensor
- Select the Sensor IQ Easy which will provide the anti-static
bar with measurement values.
- With several sensor segments , a sensor segment can be switched off.
This may be necessary in case you are using a smaller conveyor and hence a segment of
the sensor will be outside of the area of the conveyor. The anti-static bar will then calculate
using the average measurement values of the active (enabled) segments.
- To disable a segment, click
PerformaxIQEasyPerformaxIQEasySpeed_UM_9752154110_NL_D_GB_V1_2
and enter the ratio of positive ionisation using a number 0-100.
.
behind Enabled segments.
symbol.
GB
65