Omron Gentle Temp 520 Anleitung Seite 6

MC-520-E_A_M_main.book Page 6 Monday, April 16, 2018 5:03 PM
2. Preparation
2.4
Attaching a Probe Cover
Always use a new and undamaged Probe Cover MC-EP2 (MC-EP2-E).
1.
Gently twist off the probe cap.
Note: Do not forcibly remove the probe cap.
2.
Place a new probe cover on the connection ring.
Note: The adhesive side of probe cover should be upward.
3.
Insert the probe into the probe cover on the
connection ring until it clicks.
Note: When the probe cover is not attached correctly, the probe cover
symbol " " will flash on the display and a measurement can't be taken.
6
Place Adhesive Side Upward
Probe cover
Connection ring