INSIDO 89980102 Bedienungsanleitung Seite 13

89980102
PARTS AND ACCESSORIES
1. On/off switch pedal
2. Speed control button
3. Cord rewinder pedal
4. Dust full indicator
5. Hose
6. Metal telescopic tube
7. Hose connector
8. Combi nozzle
9. Locking clip of front cover
10. Floor brush
OPERATING MODE
1. Connect the hose accessories:
Press the adaptors at both side of the hose end, and then insert the hose into the hose socket.
2. Connect the extension tube to the curved hose end.
Connect the different nozzle tools/floor brush to the tube for different cleaning purposes. The floorbrush
has two positions, one for hard/even and one for soft/textile surfaces – Choose the right one.
3. Turn on the appliance:
Hold the plug and pull out the cord, then insert the plug into the power socket. Make sure that the power
supply corresponds to the required power mentioned on the rating label.
Press the on/off switch pedal to turn on the power. Adjust the power to the required level depending on
the cleaning function.
4. Turn off the appliance:
After using, press the on/off switch pedal, the appliance is turned off. Pull the plug out of the power socket;
press the cord rewind pedal, the power cord will be drawn in.
5. To move the appliance from room to room, unplug and carry it by using the handle. Never pull the appliance
by its cord when moving.
6. Tip: By reducing the suction power you can move the floor brush easier on the floor. Set the suction power
to minimal for furniture, to medium for carpet and hard floors. Only use the maximum setting on hard floors
in combination with a brush for hard floors.
MAINTENANCE
When the dust full indicator turns to red, it is time to clean the dust bag or replace with a new bag. To do that,
please follow the instructions:
a) Open the front cover by pressing the lock clip.
b) Remove the dust bag.
c) Throw the full bag away. Then take a new one, insert it into the bag holder and put it in the slot of the
cabinet.
d) Close the front cover.
NOTE:
1. The front cover cannot be closed unless the dust bag is installed in right position.
2. The motor protection filter (A) should be removed and rinsed twice a year or whenever it is visibly clogged.
If the filter is damaged, a new filter should be replaced.
- 12 -
EN