Playing Media - AEG DVD 4528 TFT Bedienungsanleitung

Terminology
Using the remote control
Loading a CD/DVD
Understanding the
onscreen CD-menu
05-DVD4528TFT_GB.indd 41 05-DVD4528TFT_GB.indd 41
Input Not Possible
If a function or input selected by you is not possible, the adjacent sym-
bol is shown on the screen.
Track:
"Track" is the designation for sections on an Audio-CD. This may be a
song, the set of a symphony, etc.
Title/Chapter:
Video-DVDs are divided into "Title" and „Chapters". A „Title" may be
e.g. a particular fi lm, the „Chapters" may be subsections of this fi lm.
MPEG4:
Your DVD player is also suitable for playing back fi les that have been
compressed using the MPEG-4 system (short for Moving Picture Ex-
perts Group-4). MPEG-4 is a compression method by means of which
large quantities of data can be reduced without any noticeable loss
of picture and sound quality.

Playing media

You transmit commands to the DVD-Player via remote control. It is thus
important to point the end of the remote control towards the DVD-
Player.
1. Press the OPEN (Fig. 1/20) button on the device. The CD/DVD tray
opens.
2. Place the CD/DVD on the tray.
3. Close the CD compartment (Fig. 1/23) again. After a short while the
type of the loaded medium is displayed (e.g. „DVD").
When playing CDs the following status information is displayed on
screen:
Current track/total number of tracks (1).
Time (2):
This provides information about the duration and the remaining
play time. By standard the play time expired of the current track
is displayed. The display is in hours and minutes. Press the
DISPLAY-button (Fig. 2/16) once or several times to have further
times displayed.
The following possibilities are available for selection
• time remaining to the end of the track,
• playback time of the CD so far,
• time remaining to the end of the CD.
English
41
30.11.2007 9:50:05 Uhr 30.11.2007 9:50:05 Uhr