Explanation Of Symbols; Safety Instructions - Perles HSW4186 Bedienungsanleitung

conditions this can affect other devices. If network
impedance is lower than XX :, disturbances should not
appear. See table:
Model
HSW 6236, HSW 6238, HSW 6256,
HSW 6258, HSW 6236K, HSW 6238K,
HSW 6256K, HSW 6258K
HSW6206K, HSW 4186, HSW 4188,
HSW 4186K, HSW 4188K
FIGURE DESCRIPTION
Figure :
Thread for adjusting auxiliary handle (3x)
Auxiliary handle
Guard
Guard crank
Handle nut
Screw holes (4x)
Flange
Flange nut
Spindle lock-off button
Spanner
Main handle
Handle lock-off crank
Crank switch
Lock-off button
Grinding/cutting disc
Rubber plate
Abrasive paper
Wire brush
Figure : Fitting the auxiliary handle
Figure : Turn of the guard
Figure : Fitting the guard handle
Figure : Removing the guard
Figure and Figure
Figure and Figure
Figure : Position of worker during work

EXPLANATION OF SYMBOLS

You must read safety instructions and general

safety instructions.

If dust is generated during work, you must wear
a protection mask.
You must read safety instructions and
general safety instructions.
If dust is generated during work, you must
wear a protection mask.
Double isolation of the tool.
Electronic speed control
(CE and RE tool versions)
Russian certification mark
If the supply cord is damaged or torn, do not
touch it, but immediately unplug the tool. Never
use tools with a damaged supply cord.
xx
0,30 :
0,36 :
: Turn of the main handle
: Switching on the tool
Warning: Risk of personal injuries and damages
to objects.
Warning: Danger of electric shock.
Green point – ecological waste disposal
Symbol for separate collection of electric and
electronic waste
SAFETY INSTRUCTIONS
x Before you start working, read the enclosed
operating instructions and keep them in a suitable
place!
Before performing any work on the tool
disconnect the plug from power supply.
Power supply must correspond to the voltage
written on the tool's nameplate!
Plug in the tool only when the On/Off switch is
in the Off position.
At power failure immediately disconnect the
plug and release On/Off switch in the Off
position.
uncontrolled and sudden start of the tool.
Use only undamaged extension cable with
minimum conductor size 1mm
Use only extension cables that are intended for
outdoor use.
Always lead supply cord behind the tool.
Be careful that the supply cord and cable
extension do not touch the rotating parts of the
tool.
x Working area must be clean and without any
obstacles. The working area must be properly lit.
x Remove all objects from the workpiece that are in the
grinding or cutting are before you start working.
x No not use grinding or cutting discs the diameter of
which is larger than the allowed disc diameter for the
tool.
x Never use the tool without the original protection
system. No not use the tool without the original wheel
guard, a nut and a flange
x Clamp the workpiece. Never clamp the tool.
Do not use deformed or damaged grinding
discs.
x Hold the tool firmly when switching it on and pay
attention to eventual sudden movements of the tool.
!
You must mount the auxiliary handle when
working with the angle grinder.
!
Set the guard according to the auxiliary handle
position in order that sparkles are directed away
from the operator.
x Before use you must compare the number of
revolutions on a cutting or grinding disc with the
number of revolutions on the tool's nameplate.
17
This way you will
2
.
prevent