Warranty And Liability; Safety Instructions; Use; Description - SATA dry jet 2 Betriebsanleitung

Operating instructions SATA dry jet 2
EN

1.4. Warranty and liability

The SATA General Conditions of Sale and Delivery and further contractual
agreements apply, if applicable, as well as the valid legislation at the time.
SATA is not liable in case of
■ non-adherence to the operating manual.
■ use of untrained personnel.
■ improper use of the product.
■ personal protection gear not being used.
■ original accessory and spare parts not being used.
■ unauthorised modifications or technical changes.
■ natural wear and tear.
■ abnormal impact.
■ impermissible assembly and disassembly work.

2. Safety Instructions

Read and comply with all directions listed in the following. Non-compli-
ance or incorrect compliance can lead to malfunctions or severe injuries
and even death.
2.1. Requirements regarding personnel
The dry jet gun may only be used by experienced skilled workers and
instructed persons who have thoroughly read and understood these op-
erating instructions. Do not use the dry jet gun when tired or under the
influence of drugs, alcohol or medication.

3. Use

Intended Use
The dry jet gun is used for forced curing of waterborne paints. Smaller
surfaces such as doors or wings can be dried with a single hand-operated
dry jet gun. The stand version with several dry jet guns can be used for
larger surfaces.
Incorrect use
Incorrect use refers to using the dry jet gun to cure solvent-borne materi-
als.

4. Description

The dry jet gun is connected to the compressed air circuit by a connec-
tion nipple. The sucked in air is cleaned by a sieve. The integrated air
flow control and the rotating flat fan nozzle point the air directly onto the
sprayed surface. The dry jet gun consists of the main parts:
■ Filter holder [1-1] with sieve [1-2]
62