Warranty And Repair; Maintenance; Main Voltage; Line Fuse - Hameg HM8130 Handbuch

extended periods of time requires the horizontal or tilted
(handle) position.
Nominal specifications are valid after 30 minutes warm-up at
23 deg. C. Specifications without tolerances are typical values
taken of average production units.

Warranty and Repair

HAMEG instruments are subject to a strict quality control. All
instruments are burned in for 10 hrs prior to shipment. Alm-
ost all early failures are detected by intermittent operation.
After burn-in a thorough test of all functions and of quality is
run, all specifications and operating modes are checked.
In case of claims during the two years warranty period please
contact the dealer from whom you purchased your HAMEG
instrument. Customers from the Federal Republic of Germany
may directly contact HAMEG for warranty processing in order
to speed up the procedure.
The proceeding of repairs during the warranty period is subject
to our terms of warranty which are available on our web-site
(http://www.hameg.com). Even after expiry of the warranty
period please do not hesitate to contact our HAMEG customer
service for repairs and spare parts.
Return Material Authorization (RMA):
Before sending back your instrument to HAMEG do apply for
a RMA number either by fax or on the Internet: http://
www.hameg.de.
If you do not have suitable packaging for the in-strument on
hand please contact the HAMAG sales department (Tel.: +49
(0) 6182/800 300, E-mail: vertrieb@hameg.de) to order an
empty original cardboard box.

Maintenance

The instrument does not require any maintenance. Dirt may
be removed by a soft moist cloth, if necessary adding a mild
detergent. (Water and 1 %.) Grease may be removed with
benzine (petrol ether). Displays and windows may only be
cleaned with a moist cloth.
Do not use alcohol, solvents or paste. Under no
circumstances should any fluid be allowed to get
into the instrument. If other cleaning fluids are
STOP STOP
used damage to the lacquered or plastic surfaces
is possible.

Line fuse

The instrument has 2 internal line fuses: T 0.8 A. In case of a
blown fuse the instrument has to be sent in for repair. A change
of the line fuse by the customer is not permitted.

Power switch

The instrument has a wide range power supply from 105 to
253 V, 50 or 60 Hz ± 10 %. There is hence no line voltage selector.
I m p o r t a n t h i n t s
Subject to change without notice
19