Getting Started - Noxon iRadio 1 Bedienungsanleitung

NOXON iRadio 1
Remote Control
Remember to pull out the clear plastic tab from the battery compartment before using
the remote.
To remove the battery from the remote, use your thumb to press the notched clip towards
the center of the battery tray and pull it out. Replace it with a CR2025 type 3V battery,
taking care to insert it with the positive (+) side up.
You can also control your iRadio via AirMusic Control App. Just download the App on
AppStore or on Google Play for Andriod systems.

3. Getting Started

The packaging box contains the following items:
NOXON iRadio 1
Remote Control
External power supply
Quick Start Guide
Service Card
Get the network ready for wireless LAN (WLAN) network connection:
Check if WLAN LINK/ACT light of the wired/wireless access point or router is illuminated.
Consult the user guide of AP or router for any questions.
Note: WiFi allows data transfer over short distances within 20 meters without the need of
cabling between the devices. Any walls or ceilings may reduce the strength of the WiFi
connectivity. Therefore try to locate NOXON iRadio and/or the access point within the
distance mentioned above, and avoid any obstacles between two devices.
Connect the power adaptor to the back of NOXON iRadio and plug into power socket.
Switch it on at the back of NOXON iRadio. When you switch on your NOXON iRadio for
the first time, the system will ask you to set Language and Network Configurations.
Please search for Software update immediately, after connecting your NOXON iRadio
to the internet.
IMPORTANT: Do not remove the power cable of the iRadio during the software update!
See 5 for detailed network configuration.
You may setup the network connection immediately, or set it later.
Press STANDBY to enter standby mode. The time, date and any active alarm times
display on the screen.
24