Jansen HKT 604 ZB Lite Slider Gebrauchs- Und Montageanweisung Seite 35

(mm)
Type
(mm)
Type
Instructions for assembly
Clips
• Drive the clips into the worktop cut-out at
the intervals indicated.
• It is not necessary to adjust the height due
to the horizontal stop.
• The horizontal drive of the clips must be
fl ush with the worktop (avoid the risk of
fractures).
• Position the hob according to the illust-
ration on the left side (a), align it (b) and
insert the clips (c).
• Screws may be used to fasten the clips.
Important:
There is a risk of breakage if the hob is can-
ted or subjected to stress during installation!
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
Bracket
• Insert the hob and align it.
• From the bottom, insert the brackets with
screws in the holes provided for fastening
the brackets, align the brackets and screw
them tight.
• Tighten the screws with a hand screw
driver only; do not use a battery-operated
screw driver.
• In the case of thin worktops make sure
that the brackets are correctly positioned.
Important:
There is a risk of breakage if the hob is can-
ted or subjected to stress during installation!
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
GB
35