Automatic Boost Function; Switching On The Second Element - Jansen HKT 604 ZB Lite Slider Gebrauchs- Und Montageanweisung

Cooking level Automatic boost
Setting
1
2
3
4
5
6
7
8
9
Operation
function
Time (min:sec)
00:45
02:20
03:50
05:00
06:38
02:00
02:45
03:35
- : -

4.13 Automatic boost function

Food is parboiled at power setting 9 with the automatic boost
function. After a certain time, the power level will switch down
automatically to a lower simmering setting (1 to8).
When using the automatic boost function only the simmering
setting with which the food is to be cooked through needs to
be selected since the electronic unit switches down automati-
cally.
The automatic boost function is suitable for dishes which are
cold initially and are then heated up at high power. These dis-
hes do not need to be constantly monitored when simmering
(e.g. boiling meat for soups).
1. Switch on the hob.
2. Use the power setting display (as a key) to select a cook-
ing zone. The stand-by dot of the cooking zone selected
must light up.
3. Press the touch control
tely set power level 9.
The touch control
afterwards. The symbol A will light up.
4. Then immediately move the fi nger you have placed onto
the touch control
levels 1 to 8.
This will activate the automatic boost function.
A and the selected simmering setting will blink alternately.
5. The automatic boost function will operate as programmed.
After a certain time (see chart) the cooking process will be
continued with the simmering setting. The A symbol will go
off .
Notes
• The simmering setting can be raised while the automatic
boost function is in operation. A reduction in the simmering
setting will switch off the automatic boost function.
• If, after activating the automatic boost function, the power
level is left at level 9 and no lower simmering setting is
selected, the automatic boost function will be switched off
automatically after 10 seconds and the cooking level will
remain at 9.

4.14 Switching on the second element

(only for cooking zones with several circuits)
Two-circuit connection of the respective cooking zone can
only be eff ected after the corresponding cooking zone has
been switched on.
1. Select the desired cooking level 1-9.
2. Switch on the second heating circuit with the circuit activa-
tion key .
The control lamp will light up.
3. The outer heating circuit will be switched off when the
circuit activation key
The control lamp will go off .
Please note
• Manually activated heating circuits will automatically be
deselected when the cooking zone is switched off .
on the right to immedia-
must be activated immediately
to the left to set simmering
is pressed again.
GB
31