Operating The Hob With The Sensor Keys; Worth Knowing About The Slider (Sensorfi Eld) - Jansen HKT 604 ZB Lite Slider Gebrauchs- Und Montageanweisung

3.1 Operating the hob with the sensor keys

The glass ceramic hob is operated with touch control sen-
sor keys. The sensor keys are operated as follows: lightly
touch a symbol on the surface of the ceramic glass plate. A
buzzer will indicate when the controls have been operated
correctly.
The touch control sensor key will then be indicated as
"key".
ON/OFF key (7)
This key is used to switch the entire hob on and off . It is,
as it were, the main switch.
Power setting display
The power setting indicator shows the power setting which
has been selected, or:
...............Residual heat
...............Automatic boost function
...............Stop function
................Childproof lock (Child-Lock)
...............Keep-warm function
...............Consistent actuation
...............Error
The corresponding cooking zone will be selected when the
power setting display is touched. The stand-by dot (9)
of the cooking zone selected will light up.
Circuit activation key
To activate other heating circuits.
Stop key (13)
The STOP function can be used to briefl y stop the cooking
process.
Recall function (13) (recovery function)
The most recent setting can be recovered if the hob is
switched off unintentionally.
Timer display and key too (14)
For programming the automatic switch-off device (timer)
and the minute minder.
The timer is activated when the timer display is touched.
Appliance description
and key (8) too
(11)
3.2 Worth knowing about the slider (sensorfi eld)
In principle, the slider functions the same as the touch
controls; the only diff erence is that you can put your fi nger
on the glass ceramic surface and then move it around.
The sensor fi eld recognises this movement and raises or
lowers the display setting (power level) in accordance with
the movement.
The term sensor fi eld is used to mean slider from now on.
Sensor fi eld
What must be observed when operating sensor fi elds?
Your fi nger should not be placed fl at onto the glass cera-
mic surface in order to avoid adjacent keys/sensor fi elds
from reacting by mistake.
unsuitable
Press the sensor fi eld lightly or move your fi nger
around
You can press the sensor fi eld very lightly with your fi nger;
when this is done the setting on the display (power level)
will gradually change.
When you put your fi nger on the sensor fi eld and then
move it to the left or right, the display setting will change
progressively.
The faster the movement, the faster the change in the
display.
touch
GB
right
move
25