Replacing The Lamp - Inventum IOP6272BK Benutzerhandbuch

1. Open the door (A) of the appliance.
Caution:
Do not use a sharp object to open the levers. This can cause damage to the appliance.
2. Open the levers (B) on each side of the door.
3. Close the door halfway.
4. Remove the door. Use both hands.
5. After cleaning, install the door again. Refer to section
INSTALLING THE DOOR
Warning:
Risk of injury. Keep your hands away from the hinges.
1. Carefully place the door (A) in the appliance.
Caution:
Make sure that the hinges are placed correctly. If the hinges are placed incorrectly, you cannot open
the door.
2. Open the door.
3. Close the levers (B) on each side of the door.
4. Close the door of the appliance.
REMOVING THE COVER OF THE DOOR
1. Push the pins (A) on each side of the door.
2. Remove the cover (B).
Note:
When the cover is removed, the glass panels inside the door are also accessible.
3. After cleaning, install the cover again. Refer to section
INSTALLING THE COVER OF THE DOOR
Caution:
Make sure that the glass panels are installed correctly.
1. Carefully push the cover (A) in the door until you hear a click.

REPLACING THE LAMP

Warning:
Make sure that the appliance is cooled down.
Preliminary requirements
1. The appliance is switched off.
2. The appliance is disconnected from
the mains supply.
42 • English
'Installing the door'
.
'Installing the cover of the door'
• Halogen lamp (25W, 230V, T300°C)
(Figure 13)
(Figure 14)
(Figure 15)
.
(Figure 16)