Dell PowerEdge R910 Systems Informationsaktualisierung Seite 10

Removing Memory Modules
WARNING:
system has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges and avoid
touching the components on the memory module.
CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
CAUTION:
installed in any memory socket that is not occupied. Remove memory-module
blanks only if you intend to install memory modules in those sockets.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" in the Hardware Owner's
Manual.
3 Remove the memory risers. See "Removing a Memory Riser" in the
Hardware Owner's Manual.
4 Press the tabs in the direction of the arrows and lift the memory
module cover. See Figure 2.
CAUTION:
not to touch the middle of the memory module.
5 Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket.
6 Press the four tabs and close the memory module cover. See Figure 2.
10
Downloaded from www.Manualslib.com
The memory modules are hot to the touch for some time after the
Many repairs may only be done by a certified service technician.
To ensure proper system cooling, memory-module blanks must be
Handle each memory module only on either card edge, making sure
Information Update
manuals search engine