Balluff BIW1-C310-M Serie Kurzanleitung Seite 5

BIW1-C/E310/317-M_ _ _ _-P1-SA002-ZA0F
Micropulse Transducer in Profile Housing
Wiring
Pin BIW1-C310... BIW1-C317...
Output signal:
4 0...20 mA 20...0 mA
Supply voltage:
3
1
Note: The increase in the output
signal is permanently defined for
devices with ZA0F plugs.
Startup
Observe all relevant safety
regulations!
Check connections: Components
can be damaged by improper
connections and overvoltage.
Verify all connections before
applying power!
Turning on the system: Note that
the system may execute
uncontrolled movements when the
transducer is part of a closed-loop
system whose parameters have
not yet been set. Therefore make
sure that no hazards could result
from these situations.
BIW1-E310...
4...20 mA
GND
+24 V DC
Pin numbering for
connector, view of
BIW side
Check functionality: The
functionality of the transducer
system and all its associated
components should be regularly
checked and recorded.
Fault conditions: When there is
evidence that the transducer
system is not operating properly, it
should be taken out of service and
guarded against unauthorized use.
BIW1-E317...
20...4 mA
System and control cabi-
net must be at the same
ground potential.
english
2