Activation; Complete Activation - Abus Terxon MX Bedienungsanleitung

6

Activation

6.1

Complete activation

The alarm system is usually completely activated if you
UK
intend to leave the object completely unattended. The
alarm centre can be activated only if all zones are ready –
i.e., all windows and doors are closed. There are two
ways of completely activating the alarm system via the
control unit (another way is via a key switch, see page 8):
1.) Enter a valid user code:
and then press:
2.) Enter a valid user code:
(In Single System only. In a Partitioned System
only partition A will be activated).
You now have three variants, depending on how the alarm
centre was programmed to behave when you activate the
alarm system:
a) Exit delay
The alarm system is activated after the specified
exit delay time expires.
b) Last door
The alarm system is activated when you close a
zone with the entry/exit property.
c) Manual
The alarm system is activated when a contact
connected to the control unit is closed.
1 2 3 4
.
1 2 3 4
and then press:
Exit delay
If the exit delay variant is programmed, you now see the
following on the LCD display:
The alarm centre has now started the exit delay time so
that you can leave the object. The delay time is now
counted down in seconds. A constant signal tone is now
generated for the duration of the delay time (if you hear no
constant tone, read the section "Open zones" on page 7).
IMPORTANT: The signal tone is generated only if this is
set in the program menu.
Last door
If the last door variant is programmed, you now see the
following on the LCD display:
The alarm centre now generates a constant signal tone (if
you hear no constant tone, read the section "Open zones"
on page 7). You can now leave the object. The alarm
system is not activated until you close a zone with the
entry/exit property. If this zone is already closed when you
activate, it must be opened and closed again (opening
and closing the entrance door). The alarm system is
activated seven seconds after the zone is closed.
IMPORTANT: The signal tone is generated only if this is
set in the program menu.
6