Silvercrest SKMP 1300 D3 Bedienungsanleitung Seite 43

Mounting the blender jug
1. Reach into the recessed grip and re-
move the cover 8 upwards.
2. Position the blender jug 5 on the drive
unit 9 so that the white arrow ( ) on
the bottom of the blender jug points to
the open lock symbol.
3. Turn the blender jug 5 clockwise until it
is firmly in place. The white arrow ( )
now points to the closed lock symbol.
Adding ingredients
• First add the liquid ingredients to the
blender jug 5, and then the solid ones.
• Cut the solid ingredients into small piec-
es in advance, so that the pieces do not
get jammed in the blades.
• During blending, you can add ingredi-
ents through the refill opening 3 in the
lid 2:
- Reduce the speed to 1 - 2.
- Rotate the lid of the refill opening 1
anticlockwise and remove it.
- Add the ingredients.
- Replace the lid 1 such that the small
plastic nibs fit into the recesses at the
refill opening 3.
- Turn the lid 1 clockwise until it is firm-
ly in place.
Mounting the lid
NOTES:
• For safety reasons, the blending process
will only start when the lid 2 is correctly
mounted.
• To make it a little easier to close the
lid 2, place a few drops of cooking oil
onto a cloth and rub it over the seal 4.
4. Place the lid 2 slightly distorted onto the
blender jug 5.
5. Rotate the lid 2 clockwise until it stops.
The device is now fully assembled.
On working with the device: see "Basic op-
eration" on page 42.
41
GB