Herunterladen Diese Seite drucken

AUDIOropa PROLOOP C Bedienungsanleitung Seite 15

Ringschleifenverstärker

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5.1 Configuring the amplifier
Two audio sources can be connected to the symmetrical XLR jacks (13). If a microphone is
connected, the corresponding jumper must be configured accordingly.
If phantom-fed microphones are used, a 40 V phantom voltage can be added.
Input IN3 (12) is exclusively designed for devices with Line level and cannot be configured
with the jumpers.
In the standard configuration, input IN1 is for "microphone" with phantom voltage, input IN2
for "Line IN" without phantom voltage.
If you want to alter the standard setting, first pull the plug out of the wall outlet and then
remove the device cover and configure the device according to the following directions:
Figure: Jumper positions
Jumper
IN1
S1 / S2
S3
IN2
S4
S5 / S6
IN3
-
* With phantom voltage switched on, do not connect a microphone or a Line-IN device with
an unbalanced jack - this could otherwise result in damage to the device!
Function
Phantom voltage IN1 *
Sensitivity IN1
Sensitivity IN2
Phantom voltage IN2 *
-
Open
Closed
Off
On
Microphone Line In
Microphone Line In
Off
On
-
-
Default setting
On (closed)
Microphone (open)
Line In (closed)
Off (open)
-
English 15

Werbung

loading