Operation; Other Symbols In This Documentation; Information On The Appliance; Units Of Measurement - STIEBEL ELTRON WS-1 Bedienung Und Installation

OPeRATION

Safety

1.3 Other symbols in this documentation

Note
General information is identified by the adjacent sym-
bol.
f Read these texts carefully. f
Symbol
Material losses
!
(appliance damage, consequential losses and environ-
mental pollution)
Appliance disposal
f This symbol indicates that you have to do something. The f
action you need to take is described step by step.

1.4 Information on the appliance

f Always observe the information on the appliance and f
keep it legible.

1.5 Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1

Intended use

The appliance is intended for decentralised dHW heating and
for heating water distribution.
The appliance is intended for domestic use. It can be used safe-
ly by untrained persons. The appliance can also be used in
non-domestic environments, e.g. in small businesses, as long
as it is used in the same way.
Any other use beyond that described shall be deemed inappro-
priate. Observation of these instructions and of the instructions
for any accessories used is also part of the correct use of this
appliance.
18 |

2.2 Safety instructions

WARNING Injury
!
The appliance may be used by children aged 8 and
older and persons with reduced physical, sensory
or mental capabilities or a lack of experience and
know-how, provided that they are supervised or
they have been instructed on how to use the ap-
pliance safely and have understood the potential
risks. Children must never play with the appliance.
Children must never clean the appliance or perform
user maintenance unless they are supervised.
WARNING Burns
- Hot water or steam may escape.
- Pipework and parts of the appliance may be-
come hot.
Material losses
!
In the event of water damage, immediately shut down
the appliance.
Material losses
!
The user should protect the system against moisture
and frost.
Material losses
!
There is a risk of fire.
f do not store any combustible materials near the f
appliance.
Note
do not cover the air slots in the casing door.
f ensure adequate air circulation. f

3. Appliance description

The appliance provides the required amount of dHW at the
preferred temperature at the draw-off points. This occurs with-
in the output limits of the appliance. Heating water is distrib-
uted to the connected radiators.
4. Cleaning, care and
maintenance
A damp cloth is sufficient for cleaning the casing. Never use
abrasive or corrosive cleaning agents.
The heat exchanger requires regular cleaning, depending on
water quality. Have the appliance cleaned by a qualified con-
tractor after no more than 2 years. The qualified contractor
will then determine the intervals at which it should be cleaned
thereafter.
WS, WS-G