Blaupunkt AHE601 Bedienungsanleitung Seite 7

AHE601
1. Top cover
2. Internal cover
3. Filter
4. Overflow outlet
5. Maximum-water-level marking
6. Control panel:
USING THE APPLIANCE
1. Refill the water tank. You can pour water from the container through the top cover, or place the air
humidifier under a tap, making sure that the appliance body's bottom does not get immersed in water
or exposed to moisture.
2. Connect the appliance to the power source. The appliance will emit an audible signal, and enter the
sleep mode; the power button will be slightly illuminated.
3. To switch on the appliance, press and hold (approx. 2 s) the power button. The air-humidity
indication and tank-water level will be displayed.
4. After 10 seconds of inactivity, the buttons' illumination will be switched off, but the power switch
will be slightly illuminated. To activate the buttons, short-press the power button.
5. To change the appliance's operation mode, press the operation-mode button (6f ). Each press results
in a mode change:
-> automatic -> silent -> intensive
6. Press the night-mode button (6e) to activate the night mode. The display will switch off, and the only
active button will be the night-mode button. The operation mode will be changed to silent. To
deactivate the night mode, press the night-mode button again.
7. You can set the timer by pressing the timer button (6d). Each press changes the timer time:
-> 1h -> 2h -> 4h -> 8h -> --
The "--" symbol indicates that the timer function is inactive. To deactivate the timer, press and hold the
timer button for 3 seconds.
8. The water-level indicator consists of 4 lines. 4 lines indicate that the tank is 100%-75% full, 3 lines
indicate 75%-50% of the tank capacity, 2 lines mean 50%-25% capacity, and 1 line = below 25%. If there
is no water in the tank, the indicator will change colour to red, and flash. When the appliance is on and
the tank is being refilled, the indicator will signal reaching the maximum level by 4 lines flashing and
few audible signals.
Note: The control panel with the display is waterproof; however, water drops can affect the buttons,
causing the function to activate and deactivate.
CLEANING AND MAINTENANCE
1. Rinse the water tank regularly, and wipe the interior with a soft sponge.
Note: Do not immerse the appliance; and prevent water from entering the appliance interior.
2. Rinse the filter regularly under running water - at least once a week. Do not use brushes or other
tools to clean the filter. Do not clean the filter in a dishwasher or a washing machine.
3. In order to remove deposits (limescale) from the filter, it is recommended to leave the filter
immersed in a descaler-, or a citric-acid solution, for some time (30-60 minutes), then to rinse the filter
thoroughly under running water.
a. Humidity-level indicator
b. Tank-water-level indicator
c. Power button
d. Timer button
e. Night-mode button
f. Operation-mode button
g. Operation-mode indicator
5