AVIRE DCP Installationsanleitung Seite 4

8. Clamp the power cable using the grey clamp provided inside the box.
9. Place the lid back on the top of the DCP and fasten the lid with the screw.
10. Turn on the power to the DCP. The RUN LED on the DCP should change colour
from flashing amber to flashing green when the mains power connection is made.
If you see any other colour, please consult the LED Indication list on page 15.
RUN LED flashes green
BAT LED is always on
SIM LED is green or amber
Coverage LED is green or amber
SLIC LED is green
11. To fix the device in position, drill two holes in the wall and insert the wall plugs and
screws provided with the device. Hang the DCP on these two points using the tear-
shaped holes at the back box of the DCP (mid points of holes are 105mm apart).
12. If a non-Avire SIM card is used, APN settings must be set prior to configuring it on
the Avire Hub; please refer to "Setting Parameters on non-Avire SIM cards" (page
6). If the SIM LED is flashing red, please see "SIM Card unlocking" (see page 5).
J6
Power supply is OK
Battery is OK
Device is connected to the network
Good coverage
Device is in standby
105mm
4