AVIRE DCP Installationsanleitung Seite 2

ELEVATOR SAFETY
Please follow all Health and Safety rules & take all necessary precautions before and
during installation.
SETTING UP THE DCP
Avire SIM cards come activated and ready to be installed. If a non-Avire SIM card is
used, please make sure that the SIM card is activated and unlocked.
1. Open the DCP with a PZ1 screwdriver.
2. Insert SIM into J4, pushing the SIM until it clicks.
3. Connect the antenna on the DCP to J2 and
ensure it is completely tightened.
NOTE: Only use antennas authorised by Avire.
4. Connect the battery to J3.
5. Wait for the LED lights to turn on.
Check the SIM LED to make sure it is
green or amber (check step 10). If it's
flashing red check it's been inserted
correctly and then unlock the SIM
card using instructions on page 5.
6. Check the signal strength by using the built-in
network signal strength scanner. To use the signal
scanner function:
+ Turn SW1 dipswitch 1 to ON (check dipswitch 4 is
also ON)
Please refer to pages 13 and 14 for the full picture
and connector information
SIM0
J2
J3
SW1
2