AVIRE DCP Installationsanleitung Seite 3

+
LEDs on the front of the DCP unit will show the network signal level
+
+
+
+
+
+
+
Note: The signal scanner will
+
indicate the best location for the
device to receive signal, Network
+
coverage will vary based on local
conditions.
+
+ Once finished turn SW1 dipswitch 1 back to OFF.
You can check the status of the power supply, battery, connection, coverage or
Phone Line (SLIC)
7. Connect the power supply 230VAC to J6, using the 3pin connector supplied with
the unit.
at any time by referring to the LED Indicators (page 15).
J6
SW1
Neutral
Live
3